Autodesk
ADD A NEW IDEA

Pumps

Showing 6 of 1170

Inlet pump

We are mode and more incorporating surface water systems in our ICM models and part of those systems are inlet pumps that respond to the downstream levels instead of the upstream levels. Up until now, the only way to achieve this is by creating an...
Marcel Glasbergen over 1 year ago in InfoWorks ICM / Pumps / RTC 0 Gathering support

Pump Station Modelling

Infoworks ICM pump station modelling principle is very basic, adding a pump between two nodes is highly hypothetical. There is no way to add pump station head losses. I would like to suggest incorporating pump station modelling (for Rotodynamic pu...
Guest over 2 years ago in InfoWorks ICM / Hydraulics / Pumps 1 Gathering support

Add SWMM5 Ideal Pump to InfoWorks ICM

Does InfoWorks ICM have an equivalent to an ideal pump in SWMM which pumps whatever is entering the SPS out of the SPS? It would be a good feature to include into infoworks as I needed to play around a bit to get it. I found I had to add line 2 ...
Guest about 5 years ago in InfoWorks ICM / Hydraulics / Pumps 1 Gathering support

Calculation of Pump Power in ICM

A pump curve and energy/efficiency curve can be input into the software however there is no way to output the energy used by the pump. South Gippsland Water were keen on understanding whether ICM could do this to report their energy efficiency bas...
Ann Pugh almost 4 years ago in InfoWorks ICM / Pumps 0 Gathering support

I would like the option to model pump station that operate using VFDs.

I would like to be able to enter the full and reduced speed pump curves for each pump station that is controlled by variable frequency drives. In addition, I would need the set point or control that causes the pumps to ramp up to full speed.
Guest over 4 years ago in InfoWorks ICM / Pumps 0 Gathering support

Change Variable Speed Pumps Image

The image for Variable Speed Pumps under the "Other Special Diversion Examples" section is likely wrong. Looks like it is a copy of the image for Pump discharge pipes. Would be great if you could update with the right image! Thanks
Guest over 3 years ago in InfoWorks ICM / Pumps 0 Gathering support

Disclaimer: The development, release, and timing of any features or functionality described or discussed for our products in this User Feedback Forum for Autodesk Water Products and Services remains at our sole discretion. This User Feedback Forum for Autodesk Water Products and Services is not a commitment, promise, or legal obligation to deliver any functionality, is intended solely to outline and gather feedback about our general product direction, and should not be relied on in making purchasing decisions.

Privacy | Cookie preferences