Productivity

Showing 19 of 1313

Ability to look at multiple phases (surface and foul networks together) in 3D

Being able to view both surface and foul networks within MicroDrainage was always a very useful feature to visualise crossing points in the network and it doesn't look to have been included in InfoDrainage.

Henry Wilkinson 6 days ago in InfoDrainage / Productivity 0 For Review

1 VOTE

Pipe clash detection when foul network phase is active

When working through clashes between surface water and foul networks, you can only access the pipe clash analysis within surface water analysis tab. This means if I want to change the depth of the foul network to avoid the clash then I have to swa...

Henry Wilkinson 6 days ago in InfoDrainage / Productivity 0 For Review

6 VOTE

Save phase results seperately

When working with multiple phases I would like to be able to run one phase (exclude all others from analysis) and have the results saved. Results should only be overwritten when a new run on the same phase is completed.

Andrew Komarnycky 4 months ago in InfoDrainage / Productivity 0 For Review

9 VOTE

Set gradient and/or pipe size of multiple parts within a single flow path in one operation.

In some instances we need to change the gradient or pipe size of an entire flow path. It would be helpful if this could be done in one operation rather than each part individually. Any branch connections could also update to align unless locked.

Guest 8 months ago in InfoDrainage / Productivity 1 For Review

2 VOTE

Graphical editing in Longsection

Being able to manually drag pipes up/down and alter their gradient in the long section graphics, was an extremely efficient workflow in Microdrainage, especially when using min. pipe design levels to dictate land-raise FGLs. Can this function be c...

Guest 2 months ago in InfoDrainage / Productivity 0 For Review

5 VOTE

show upstream and downstream cover depth for connections

MicroDrainage used to show this its useful for checking cover to pipes are correct

Matt Hare 7 months ago in InfoDrainage / Productivity 0 For Review

1 VOTE

Reverse Flow Direction

In cases where the pipe direction in the CAD/GIS source file is incorrect, the imported flow direction in InfoDrainage also follows the same (incorrect) path. Rather than correcting the geometry externally in CAD or GIS, is there a built-in option...

Jana Anbu about 1 month ago in InfoDrainage / Productivity 1 Will not implement

1 VOTE

Conduit Numbering

I have encountered a glitch with the conduit numbering system. While manhole numbering works as expected (check the snip), the conduit numbering is generating inconsistent formats as expected such as CO-1.001, CO.1002, and so on Our expectation is...

Jana Anbu about 1 month ago in InfoDrainage / Productivity 2 Already exists

11 VOTE

Manhole Types

Please allow us to specify manhole types (DMRB, SSG etc.) and covers and ensure that this data is visible in the manhole schedule export

Guest over 1 year ago in InfoDrainage / Productivity 1 Gathering support

6 VOTE

Show manhole types in manhole schedule export

Manhole schedules need to feature cover types (D400, C250 etc), manhole types (Type A, B, C in Scotland etc) and whether they're a backdrop or a headwall etc. Having a feature to assign this based on location on site (cover type), depth to soffit ...

Guest 11 months ago in InfoDrainage / Productivity 0 For Review

Please enter your email address

FILTER BY CATEGORY