All ideas

Showing 1370 of 1370

Give a warning when copying between networks with different user defined defaults

when copying for example conduits between networks with flags #D for headloss and roughness, the values are adapted to the user defined values in the new network. This can be confusing.

Guest almost 3 years ago in InfoWorks ICM / Flags / Import data / Productivity 0 Gathering support

16 VOTE

Cross section result view: keyboard shortcuts to go upstream or downstream

In the cross section result view (showing the water level), in RS there was the possibility to go upstream or downstream with PageUp/PageDwn, in ICM you have to right click to move upstream or downstream

Guest almost 3 years ago in InfoWorks ICM / Productivity / Results / River Modeling 0 Gathering support

16 VOTE

Bank line ground model update from within properties view

Make update from ground model possible from within properties view (as is already possible for cross sections)

Guest almost 3 years ago in InfoWorks ICM / River Modeling 0 Gathering support

15 VOTE

VSP Control based on Tank Head/Level

Currently you can only use Junction Pressure setpoints or Pump Flow setpoints in the VSP Control dialogue. It would be helpful to be able to use a Tank Level/Head setpoint to adjust the pump speed as well. This is possible in competitor products l...

Grant Clemens over 2 years ago in InfoWater Pro / Operational Modeling 3 Under consideration

10 VOTE

Add a "Pan to Selection" option in GeoPlan window

Just what the above says. The zoom in/out can be pretty touchy, particularly on track pad. While "zoom to selection" helps, if you're just trying to zoom to a single node or short link, it zooms in too close to be particularly helpful when looking...

Jacob Eck over 1 year ago in InfoWorks ICM / Visualization 1 Gathering support

25 VOTE

Zoom graphs on either axis

Many software suites allow the option to zoom in on both y and x axes on their graphs. However, ICM only allows zooming on the x-axis which often takes away the ability to see trends for lower or higher conditions. I am aware that it is possible t...

Guest over 4 years ago in InfoWorks ICM / Calibration / Productivity / Results 4 Gathering support

2 VOTE

Steady state simulations for different times or for average demand

Steady state simulations are useful for 1) evaluating an initial or simplified version of a model (for example with average demands) or 2) evaluating a specific condition (like maximum demand, etc.) without much complexity. If your model is alread...

Felipe Hernandez 4 months ago in InfoWater Pro / Engine 0 Gathering support

4 VOTE

Export functionality for SWMM objects in database tree

Be able to right-click on SWMM objects (SWMM time patterns, SWMM climatology, SWMM pollutograph) and export to CSV as you can with InfoWorks objects.

Guest 8 months ago in InfoWorks ICM / Export Data 1 For Review

8 VOTE

Allow CCTV Inspections to be associated to a pipe/culvert when PLR and asset IDs match but no manhole IDs are provided in the CCTV inspection

Allow inspections to be imported WITHOUT (i.e. missing) manhole IDs but still provide the association to the asset via the PLR if a corresponding pipe asset has the same asset ID. In the situation where there are no manhole IDs provided then I360A...

Tony Andrews over 1 year ago in Info360 Asset 0 Gathering support

6 VOTE

Comparison of total length of rehab methods vs total pipe length

Similar to 'Comparison of total length of defects vs total pipe length' however, rehab methods can be assigned to multiple defects. For example the rehab method 'lining' can be assigned to defect codes CC, CL, FM, etc. the total length of a rehab ...

Martha Nunez about 1 year ago in Info360 Asset 1 Gathering support

Please enter your email address

FILTER BY CATEGORY