Hydraulics

Include a new conduit type for tile drains

Add a new conduit type to model tile drains or underdrains. These are common in agricultural fields and certain stormwater control structures. Currently, its difficult to model these since you can't account for the time it takes to infiltrate from...

Ryan Brown over 3 years ago in InfoWorks ICM / Hydraulics 0 Gathering support

2 VOTE

Drain nodes connected to 2d domain representing road gullies to 1D pipe network without digitised connection

Often datasets of road gullies are only in point format and lack details on the connections to the surface water sewer network. A function to allow 1D nodes representing road gullies (which are are connected to the 2D domain with a head discharge ...

Guest over 2 years ago in InfoWorks ICM / Inlets 0 Gathering support

1 VOTE

add Xylem Nexicom Smart System to control pumps as a modelling option

we are increasing using Xylem Nexicom Smart System to control pumps in pumping stations across Scotland. This smart control system includes an number of functions such as Energy Minimizer and Sup and pipe cleaning . Scottish Water has found diffic...

francisco simon over 1 year ago in InfoWorks ICM / RTC 1 Will not implement

2 VOTE

Interpolate bank elevations from cross-section ends

It often happens that river reaches are constructed from traditional surveyed cross-sections, which is of a higher accuracy compared to LIDAR data. A common need is for the bank elevations between the surveyed cross-sections to be interpolated bas...

Guest about 3 years ago in InfoWorks ICM / River Modeling 0 Gathering support

3 VOTE

Revision to manhole representation

ICM's default representation of manholes could be more accurate. The limitations of current setup allows accurate representation of either the shaft or the benching but not both. Thus most people tend to apply chamber areas to invert which overest...

Guest almost 5 years ago in InfoWorks ICM / Hydraulics 0 Gathering support

2 VOTE

Map flow tracers showing flow patterns similar to what is presented in HEC-RAS 2D.

The graphics in RAS 2D make it extremely helpful for conveying flow patterns to clients and to the public. They are easily able to see where flow is coming from and can confirm with their knowledge of the areas.

Andrew Moore over 3 years ago in InfoWorks ICM / 2D Flooding 0 Gathering support

4 VOTE

Improvement on the Numerical Correction Process in ICM

The current procedure for ‘Numerical Correction’ in ICM requires users to remove any existing values to calculate the correction (for Preismann and Base flow) before the inbuilt routine is run. If this wasn't made the calculated correction values ...

Guest almost 7 years ago in InfoWorks ICM / Hydraulics 1 Gathering support

3 VOTE

Calculation of Pump Power in ICM

A pump curve and energy/efficiency curve can be input into the software however there is no way to output the energy used by the pump. South Gippsland Water were keen on understanding whether ICM could do this to report their energy efficiency bas...

Ann Pugh almost 6 years ago in InfoWorks ICM / Pumps 0 Gathering support

1 VOTE

Results tool tips for 2D Zone

Interactive tooltip appear to be missing 2D Zone element results...

Guest about 2 years ago in InfoWorks ICM / 2D Flooding 1 Under consideration

3 VOTE

I would like the option to model pump station that operate using VFDs.

I would like to be able to enter the full and reduced speed pump curves for each pump station that is controlled by variable frequency drives. In addition, I would need the set point or control that causes the pumps to ramp up to full speed.

Guest over 6 years ago in InfoWorks ICM / Pumps 0 Gathering support

Please enter your email address

FILTER BY CATEGORY