Ideas

Showing 942 of 1442

Add SWMM5 Ideal Pump to InfoWorks ICM

Does InfoWorks ICM have an equivalent to an ideal pump in SWMM which pumps whatever is entering the SPS out of the SPS? It would be a good feature to include into infoworks as I needed to play around a bit to get it. I found I had to add line 2 ...

Guest over 6 years ago in InfoWorks ICM / Hydraulics / Pumps 1 Gathering support

2 VOTE

Allow to add non-equidistance rainfall data

Rowan De Costa almost 2 years ago in InfoWorks ICM / Rainfall 2 Gathering support

3 VOTE

Ability to change appearance of snapping 'cross-hairs'

When drawing subcatchments, you normally need quite a few layers showing - the modelled sewer network, a shapefile showing smaller private laterals, the DTM, OSMM. The snapping mode 'cross-hairs' can often get lost in the mix of colours, especiall...

Jason Kulsdom almost 3 years ago in InfoWorks ICM / Productivity 0 Gathering support

5 VOTE

Export river cross sections for an ICM model

At present, ICM river cross sections can only be exported to dwg one by one. It would be helpful to be able to export all the modelled cross sections in a single operation (eg via data export centre)

Guest over 4 years ago in InfoWorks ICM / Export Data / River Modeling 1 Already exists

2 VOTE

Play/Pause button

Current play and pause buttons (when viewing simulation results) are separate. I realise there are step buttons but if I want to start/stop quickly, whilst looking at the results instead of where the mouse is, then it's more convenient as a single...

Matthew Paul almost 2 years ago in InfoWorks ICM / Productivity 0 Gathering support

3 VOTE

Update downstream pipes

It would be useful to have an option to upsize downstream pipes automatically (just like microdrainage). For example, if i increase pipe size the corresponding downstream pipes should upsize accordingly so not to cause a restriction. At the minute...

Guest almost 3 years ago in InfoDrainage / Productivity 2 Already exists

2 VOTE

ICM SWMM should show the Pipe Slope and Full Flow (PFC) on the Properties Dialog

While it might seem like a small detail, the ability to access the same properties on a Grid in ICM SWMM that were available in InfoSWMM can significantly enhance user experience. Many users request to see properties such as pipe slope and PFC val...

Robert Dickinson almost 2 years ago in InfoWorks ICM / Grids 0 Gathering support

4 VOTE

Faster release Exchange license

After a user uses the Exchange license, it takes ages before the license is released again so another user can use it.

Marcel Glasbergen almost 4 years ago in InfoWorks ICM / API / Exchange 2 Will not implement

2 VOTE

Drain nodes connected to 2d domain representing road gullies to 1D pipe network without digitised connection

Often datasets of road gullies are only in point format and lack details on the connections to the surface water sewer network. A function to allow 1D nodes representing road gullies (which are are connected to the 2D domain with a head discharge ...

Guest almost 2 years ago in InfoWorks ICM / Inlets 0 Gathering support

4 VOTE

odour

Air Phase Model Function - Can Innovyze consider to include air phase modelling function in InfoWorks? At moment, the odour modelling is done separately by various methods using the sewer hydraulic data as the input. As a result, the odour modelli...

XJ Wang almost 4 years ago in InfoWorks ICM / Pollutants / Water Quality 0 Gathering support

Please enter your email address

FILTER BY CATEGORY