Ideas

Showing 170 of 1370

Graph RTC variables

RTC variables can be useful when modelling complex systems, but while I can check individual timestep values of variables using the log, it would be helpful to be able to visualize these on a graph (and compare it with other simulation results).

Iain Scott 7 months ago in InfoWorks ICM / Results 3 Gathering support

12 VOTE

Provide InfoWater Pro integration with Civil 3D

Engineers and designers using Civil 3D for water distribution system design need to be able to verify the hydraulic adequacy of their designs quickly and efficiently in InfoWater Pro. There is currently no means by which to exchange Pressure Netwo...

Michael Kane almost 2 years ago in InfoWater Pro / Data Exchange 1 Under consideration

1 VOTE

Batch Multi Fire Flow

I want the ability to model many different cases of multi-fire flow in parallel. This is important because I have many areas that require fire flow that is greater than what a single hydrant and later can achieve. Performing this manually for each...

Nathan Gerdts about 2 months ago in InfoWater Pro / Automation 0 Gathering support

2 VOTE

simulation .elog file available via UI

Prior to ICM 2025, right clicking on the completed simulation > Open As would give access to the "simulation log", which contained useful details about the initialisation and failure reasons of the simulation. It would also contain diagnostics ...

Iain Scott 4 months ago in InfoWorks ICM / Results 1 Under consideration

4 VOTE

Extra Results Outputs for some features in ICM

Hi there - Doing some work for a client I found the following limitations in results exports from Infoworks ICM: 2D Base Linear Structure: ls_underflow and ls_overflow results variables cannot have a summary of peak value exported by CSV or SHP. T...

Guest 8 months ago in InfoWorks ICM / Results 0 For Review

16 VOTE

Cross section result view: keyboard shortcuts to go upstream or downstream

In the cross section result view (showing the water level), in RS there was the possibility to go upstream or downstream with PageUp/PageDwn, in ICM you have to right click to move upstream or downstream

Guest almost 3 years ago in InfoWorks ICM / Productivity / Results / River Modeling 0 Gathering support

15 VOTE

VSP Control based on Tank Head/Level

Currently you can only use Junction Pressure setpoints or Pump Flow setpoints in the VSP Control dialogue. It would be helpful to be able to use a Tank Level/Head setpoint to adjust the pump speed as well. This is possible in competitor products l...

Grant Clemens over 2 years ago in InfoWater Pro / Operational Modeling 3 Under consideration

25 VOTE

Zoom graphs on either axis

Many software suites allow the option to zoom in on both y and x axes on their graphs. However, ICM only allows zooming on the x-axis which often takes away the ability to see trends for lower or higher conditions. I am aware that it is possible t...

Guest over 4 years ago in InfoWorks ICM / Calibration / Productivity / Results 4 Gathering support

2 VOTE

Steady state simulations for different times or for average demand

Steady state simulations are useful for 1) evaluating an initial or simplified version of a model (for example with average demands) or 2) evaluating a specific condition (like maximum demand, etc.) without much complexity. If your model is alread...

Felipe Hernandez 4 months ago in InfoWater Pro / Engine 0 Gathering support

11 VOTE

Please add an Innovyze section to the autodesk forums

Hello, Innovyze previously had a forum available for their products. After the software was purchased by autodesk, this no longer seems to exist. I believe having a forum where users can post questions and troubleshoot their issues would be very h...

Endrit Shabani almost 2 years ago in InfoWater Pro / Other 2 Gathering support

Please enter your email address

FILTER BY CATEGORY