Autodesk
ADD A NEW IDEA

All ideas

    Showing 249

    Multi-thread parallel simulations

    As a user I want to take advantage of multi-threaded CPUs to accelerate simulation intensive procedures (e.g. design calibration)
    Guest over 6 years ago in InfoWater Pro / Engine / Productivity 3 Launched

    As a user, I would like an automated method to allocate demands from meter points through lateral polyline to pipelines.

    I need a way to allocate demand from a meter (point meter) to the pipe (polyline) based on the lateral connection (polyline) at end points. Keep in mind: The features might not snap nor connect to pipes
    Bill Maggiore almost 6 years ago in InfoWater Pro 0 Launched

    Manhole Risk

    Create risk profiles for Manhole assets which leverage MACP scores, attributes, spatial analysis for COF, LOF and total risk.
    Mike Maylone over 2 years ago in Info360 Asset 0 Launched

    Hydrant Available vs. Hydrant Design

    Has anyone had issues with the hydrant available flow being less than the hydrant design flow? It has always been my impression that the hydrant available flow has less constraints and therefore would have a higher fire flow than that of the hydra...
    Guest about 1 year ago in InfoWater Pro / Automation 2 Launched

    Automate the "geodatabase rebuild" troubleshooting process

    When models start to behave erratically or sluggish, a common recommendation is to "rebuild the model geodatabase" as shown here: https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/Troubelshoot-Map-Issues.html It wou...
    Grant Clemens over 1 year ago in InfoWater Pro / Automation 1 Launched

    Know which master database refers to a working/results folder

    Create a means to know which master database is connected to a working / results folder. i.e. to go from the long name of the working / results folder to the ICM master database. A simple text file within the folder could give the name of the mast...
    Lizzie about 4 years ago in InfoWorks ICM / Other 2 Launched

    Triangles browser

    Small triangles can slow down 2D simulations significantly. Currently, after creating a 2D mesh, I export the 2D mesh to a GIS software to check how many triangles I have below certain size and where they are. This helps me address the problem of ...
    francisco simon almost 6 years ago in InfoWorks ICM / Mesh 3 Launched

    Pipe Capacity and Flow results

    in MicroDrainage, when designing a pipe network there was a table below the main design table giving results, with Pipe flow and pipe capacity, (amongst others) this was useful to identify where to increase pipe diameters if nearing the capacity o...
    Steven Gilchrist over 2 years ago in InfoDrainage / Productivity 5 Launched

    in IWPro to have a symbol for easy indication of UPC attached to an asset

    It can be difficult to tell if UPC is attached to a pump without checking every time. It would be very helpful to have a way to show UPC, such as similar to live data.
    Guest over 5 years ago in InfoWater Pro 1 Launched

    Formatting of Reports

    The output reports from Infordrainage, are not set to fit the page and as such, there is a lot of "white space" left on the outputs. At present, there are no formatting options to change this. It makes the drainage report look a bit untidy.
    Guest over 3 years ago in InfoDrainage 3 Launched

    Disclaimer: The development, release, and timing of any features or functionality described or discussed for our products in this User Feedback Forum for Autodesk Water Products and Services remains at our sole discretion. This User Feedback Forum for Autodesk Water Products and Services is not a commitment, promise, or legal obligation to deliver any functionality, is intended solely to outline and gather feedback about our general product direction, and should not be relied on in making purchasing decisions.

    Privacy | Cookie preferences