All ideas

Showing 68

Conduit Numbering

I have encountered a glitch with the conduit numbering system. While manhole numbering works as expected (check the snip), the conduit numbering is generating inconsistent formats as expected such as CO-1.001, CO.1002, and so on Our expectation is...

Jana Anbu 8 months ago in InfoDrainage / Productivity 2 Already exists

4 VOTE

Enable drawnet manhole changes

Enable the manholes assigned to impermeable areas on drawnet to be changed. It is currently not possible to change the manhole when editing a network meaning the areas have to be deleted then recreated. Being able to change the manhole would save...

Guest about 3 years ago in InfoDrainage 1 Already exists

4 VOTE

Change the size / dimensions of multiple manholes at once

MicroDrainage Network It would be very useful if it was possible to change the dims of many manholes at once. It'a a very laborious and time consuming task to change each dimension one-by-one, especially if the network is very large!

Guest about 3 years ago in InfoDrainage 1 Already exists

4 VOTE

InfoDrainage - replace stormwater outline with DXF (or other similar file)

Would be useful to be able to 'replace outline' of a stormwater control by importing a polygon (e.g. DXF, SHP etc), rather than the existing options which are just to redraw in ID only. Every project there seems to be need to replace an outline fr...

Guest about 3 years ago in InfoDrainage 1 Already exists

3 VOTE

Update downstream pipes

It would be useful to have an option to upsize downstream pipes automatically (just like microdrainage). For example, if i increase pipe size the corresponding downstream pipes should upsize accordingly so not to cause a restriction. At the minute...

Guest over 2 years ago in InfoDrainage / Productivity 2 Already exists

5 VOTE

Export river cross sections for an ICM model

At present, ICM river cross sections can only be exported to dwg one by one. It would be helpful to be able to export all the modelled cross sections in a single operation (eg via data export centre)

Guest over 4 years ago in InfoWorks ICM / Export Data / River Modeling 1 Already exists

2 VOTE

Swale with pipe under connected by manholes

Could not model real-life scenario where the pipe was under as conveyance for lesser events and raised via vented manholes into the swale above. Need integrated solution and was unable to model both and connect via manholes.

Guest almost 2 years ago in InfoDrainage / Hydraulics 1 Already exists

2 VOTE

Remove the 'Admin' page for Viewer and Field Inspector users.

This is to prevent these users from accidentally editing this information without the Admin/Full access permission.

Martha Nunez almost 2 years ago in Info360 Asset 3 Already exists

3 VOTE

Switch design return periods when running cascade analysis

I would like to be able to build a single cascade model & able run it for various design return periods instead of needing to create separate cascade models for each return period.

Guest about 3 years ago in InfoDrainage 1 Already exists

3 VOTE

Status Bar to report more significant figures

The status bar currently only displays levels (ground model level, water depth) to 1 decimal place. 2 Decimal places would be much more useful, Especially to ensure a node is at a low point or in the gutter invert..

Guest about 3 years ago in InfoDrainage 1 Already exists

Please enter your email address

FILTER BY CATEGORY