Autodesk
ADD A NEW IDEA

InfoWorks ICM

Showing 440

Automated Calibration Tool

Tool similar to competing software where you can apply a level (%) of uncertainty and automatically sun simulations with varied parameters withing that level of uncertainty and see all results at once.
Guest almost 5 years ago in InfoWorks ICM / Calibration 1 Gathering support

GPU for 2D Erosion Deposition Model

The 2D erosion-deposition model can only be simulated on the CPU. For 2D rain-on-mesh models with GPU simulation times spanning hours, it becomes impractical to integrate the 2D erosion-deposition model, as CPU simulation times would extend into d...
Daniel Fensom over 1 year ago in InfoWorks ICM / Water Quality 0 Gathering support

Provide min_time_step on 2D results mesh

In an effort to speed simulations up - it would be helpful to know what mesh elements are slowing down a 2D simulation. A single Job Progress value is insufficient to chase down which of these 200K mesh elements is slowing down the model.
Matt Anderson over 1 year ago in InfoWorks ICM / Results 1 Gathering support

Enable Data Flags for bed levels and roughness values in river section data

Enable data flagging for the bed level and roughness values within the river cross section data. This information was available in RS and is sorely missed.
Guest about 5 years ago in InfoWorks ICM / Flags / River Modeling 0 Gathering support

Enable to choose time zone for exported radar SHP files

In general, radar files are based on UTC, and they are loaded into appropriate local time by choosing the original time zone in the radar configuration dialog. It allows ICM to load radar files with local time correctly. However, once they are exp...
Miyuki Okuda about 1 year ago in InfoWorks ICM / Export Data 0 Gathering support

Speed up the creation/amending of ICMTs

Creating or amending ICMTs is slow, especially if they contain ground models. Even deleting or creating new 'folder' items in ICMTs is slow. Speeding this process up would increase productivity.
Lizzie over 4 years ago in InfoWorks ICM / Data Exchange / Terrain 2 Gathering support

Calculating volume storage on river reaches

In the application of ICM, we often count the regulation volume of river channels.But at the moment we can only calculatethe total available volume of channels/river reaches between two cross sections by using length and cross sectional areas.If t...
Guest over 4 years ago in InfoWorks ICM / Productivity / Results / River Modeling 0 Gathering support

Sorting a conduit grid table based on upstream-downstream order (or vice-versa)

Help to sort a grid table (such as conduit) in order of upstream to downstream or vice-versa will be very helpful to modellers.
Guest over 1 year ago in InfoWorks ICM / Grids 0 Gathering support

Add the ability to drain subcatchments to the grate of a gully

When importing models from XPSWMM to ICM, my subcatchments drain directly to the node where an inlet capture curve is applied to limit flow to the 1d system. I would like to replicate this behavior easily in ICM when nodes are connected to the 2D ...
Sophia Buchanan about 1 year ago in InfoWorks ICM / Inlets 0 Gathering support

Circular sluices/penstocks would also be useful

Similar to the rectangular flap valve request, circular sluices would avoid workarounds trying to estimate the rectangular equivalent to a half closed circular penstock (or worse still a half closed egg shaped penstock)
Geoffrey Brown about 5 years ago in InfoWorks ICM / Hydraulics 0 Gathering support

Disclaimer: The development, release, and timing of any features or functionality described or discussed for our products in this User Feedback Forum for Autodesk Water Products and Services remains at our sole discretion. This User Feedback Forum for Autodesk Water Products and Services is not a commitment, promise, or legal obligation to deliver any functionality, is intended solely to outline and gather feedback about our general product direction, and should not be relied on in making purchasing decisions.

Privacy | Cookie preferences