Ideas

Showing 144 of 1370

Flow direction arrows default symbology

By default, flow direction arrows show up as blue for forward flow, red for backwards flow. This is a pointless distinction because for distribution systems, "forwards" or "backwards" depends on the direction the pipe was initially digitized and h...

Colin Ricks over 2 years ago in InfoWater Pro / Productivity 0 Under consideration

5 VOTE

Export river cross sections for an ICM model

At present, ICM river cross sections can only be exported to dwg one by one. It would be helpful to be able to export all the modelled cross sections in a single operation (eg via data export centre)

Guest over 4 years ago in InfoWorks ICM / Export Data / River Modeling 1 Already exists

2 VOTE

Report manager should populate without running model

Currently, the report manager is only populated once results are shown. This makes it so that the only place I can view the model data before running, is the data base manager. You should be able to have the report manager populated without runnin...

Endrit Shabani almost 2 years ago in InfoWater Pro / Other 0 Gathering support

1 VOTE

Option for "downstream node" when allocating demand by pipe

The current "farthest node" option I believe just places the demand at the opposite end of the pipe compared to the meter point. Instead I'd like an option for all the meter demands to be placed at the pipe's end node. "Downstream" would probably ...

Eric King 11 months ago in InfoWater Pro / Other 0 For Review

1 VOTE

Hydrant Design Flow vs Available Flow!

I don't like the new update, which makes the available flow subject to a velocity constraint. In the previous version, the pressure constraint was on the hydrant flowing, while the design flow would consider the network pressure and pipes. They sh...

Guest 11 months ago in InfoWater Pro / Engine 0 For Review

5 VOTE

Persistent Graphs in InfoWater/InfoWater Pro

Stored graphs aren't that great. Why not just make graphs persistent?

Guest almost 5 years ago in InfoWater Pro / Productivity 2 Under consideration

5 VOTE

Data Sets

It would be very helpful if, for any data set that is created by creating a clone of another data set, you could keep track of that. Perhaps a visually branched system of data sets to see if any of the sets were created based on another set. That ...

Guest almost 5 years ago in InfoWater Pro 1 Under consideration

6 VOTE

Export to Geopackage

New versions should export to more generic GIS formats so that they are independent of commercial GIS platforms.

Guest about 6 years ago in InfoWorks ICM / Export Data 1 Gathering support

2 VOTE

Horizontal surge tank equivalent diameter

I also am still assuming that if I want to model a horizontal tank, you must put in an equivalent diameter not the actual diameter.

Guest about 2 years ago in InfoWater Pro / Productivity 0 Gathering support

2 VOTE

Export results without the ICM interface

I have found that exporting 2D zones results is very slow. I would ideally like to be able to export maximum 2D zones from a series of simulations without the need to open ICM. As an added feature I would like the exported GIS files (or whatever f...

Guest over 2 years ago in InfoWorks ICM / Export Data 1 Gathering support

Please enter your email address

FILTER BY CATEGORY