All ideas

Showing 1374 of 1374

Integration and visualization of Electroscan data

Electroscan data is a condition assessment technology that uses current readings to detect potential infiltration and inflow defects along the length of the pipe. The current vs length readings can be displayed in a plot diagram in InfoAsset Plann...

Martha Nunez over 1 year ago in Info360 Asset / CCTV Standards (e.g. PACP) 0 Gathering support

3 VOTE

inlet riser option for tank

Have an option to specify an Inlet Riser Pipe for the tank element. This would hold the fill head at a constant, set at the riser pipe elevation, but allow the tank discharge head vary with the tank level.

Guest almost 5 years ago in InfoWater Pro / Engine 0 Gathering support

3 VOTE

Dashboard Not for Just Asset Module, but for part of Info360.com so KPI across multiple modules can be seen in one place.

It seems like each module is developing their own dashboard. This to me is an issue, as it violates the very definition of an integrated system and a Dashboard. People only want one Dashboard to look at. The Dashboard should be a feature in the In...

Guest almost 5 years ago in Info360 Insight 0 Already exists

3 VOTE

Dashboard Not for Just Asset Module, but for part of Info360.com so KPI across multiple modules can be seen in one place.

Guest almost 5 years ago in Info360 Asset 0 Will not implement

3 VOTE

Calculation of Pump Power in ICM

A pump curve and energy/efficiency curve can be input into the software however there is no way to output the energy used by the pump. South Gippsland Water were keen on understanding whether ICM could do this to report their energy efficiency bas...

Ann Pugh almost 5 years ago in InfoWorks ICM / Pumps 0 Gathering support

3 VOTE

Be able to drag the grid window off main interface to another monitor.

Drag grid window to another screen, just like an attribute table in ArcMap/ArcGIS Pro. Allowing more relaxed and open use of grids, with much less scrolling through tight windows.

Guest almost 5 years ago in Other Product Ideas / Storm, Sewer, Flood Modeling 0 For Review

3 VOTE

Multiple control options

Assets with controls (Pumps, PRVs etc.) should have multiple control options. So Control 1 could be a control regime applicable to model calibration. Control 2 could be control relevant to a General Applications model, Controls 3, 4, 5 etc c...

Guest almost 5 years ago in InfoWorks WS Pro / Productivity 1 Already exists

2 VOTE

Allow Theming Inflow areas by attributes

I would like to visually theme the Inflow areas by an attribute, say, Percent Impervious (PIMP)

Guest over 3 years ago in InfoWorks ICM / Theme / Visualization 0 Gathering support

3 VOTE

Export both the result and the underlying property fields

When the model results are displayed on the webpage through Exchange, since the basic properties need to be viewed, the corresponding basic properties of the results need to be exported first, and then the results are matched to the basic properti...

Liu Qiusheng almost 5 years ago in InfoWorks ICM / Export Data / Simulations 0 Gathering support

3 VOTE

Convergence Errors be resolved automatically while the model is simulated

Sometime a TSR running for few weeks throws up convergence hence these sims need to be rerun with shorter timestep which is both inefficient and a lot of time is wasted. It would be good if somehow the simulations dialog allowed to run the model w...

Salam Jamadar almost 5 years ago in InfoWorks ICM / Performance / Simulations 0 Gathering support

Please enter your email address

FILTER BY CATEGORY