Ideas

Showing 103 of 1370

leave Layers and Themes window open

Could you make it possible to work in the Geoplan without having to close the Layers and Themes window? It would make switching Layers on and off much easier. Alternatively you could add a separate window to switch layers on and off.

Richard de Koning almost 6 years ago in InfoWorks ICM / Productivity / Visualization 1 Gathering support

7 VOTE

Add node level (hydraulic grade line) data to custom graphs for calibration

Allow for the ability to compare observed and predicted level data (or hydraulic grade lines) at nodes. Instead of depth in the pipe, I typically have water surface elevations at a node, specifically for treatment plant hydraulic modeling.

Guest over 5 years ago in InfoWorks ICM / Calibration / Labels / Results 0 Gathering support

1 VOTE

Apply direct inflows to permeable paving

There should be a way of applying the inflow that the paving receives directly (i.e. the rain that falls onto it) to produce a more accurate simulation of the rainfall. This direct rainfall isn't a lateral or point inflow, and being forced to mode...

Craig Bobbett 10 months ago in InfoDrainage / Hydraulics 0 For Review

2 VOTE

Infiltration Trench using BRE DIGEST 365 method

The software needs to support for designing Infiltration trench method by using “BRE DIGEST 365”. I have checked the comparison between Infodrainage analysis Vs BRE digest 365 (manual calculation) and the results are not matching. Most of the proj...

Guest almost 2 years ago in InfoDrainage / Hydraulics 8 Gathering support

2 VOTE

Swale with pipe under connected by manholes

Could not model real-life scenario where the pipe was under as conveyance for lesser events and raised via vented manholes into the swale above. Need integrated solution and was unable to model both and connect via manholes.

Guest almost 2 years ago in InfoDrainage / Hydraulics 1 Already exists

6 VOTE

Auto populate an incremental ID for objects such as lines/polygons/subcatchments etc.

Often source data is provided with a non unique ID. Nodes auto generate an ID, and conduits will create a node, but the remaining asset classes struggle somewhat and often you need to manipulate the GIS data. I would like to be able to have ICM...

Ann Pugh over 5 years ago in InfoWorks ICM / Data Exchange / GIS Layers / Import data 0 Gathering support

5 VOTE

ICM Status bar to show more significant figures

The status bar currently only displays levels (ground model level, water depth) to 1 decimal place. 2 Decimal places would be much more useful, Especially to ensure a node is at a low point or in the gutter invert..

Gregory Smith almost 5 years ago in InfoWorks ICM / Productivity / Visualization 1 Gathering support

2 VOTE

Make Grips Visibile

Lets get Grips, and make them visible! Autodesk is damn good at this. ICM is not.

Guest about 2 years ago in InfoWorks ICM / Visualization 0 Gathering support

3 VOTE

compatibility with WMTS servers

Compatibility with WMTS servers for the GIS layer control would be very urgent. Right now a lot of data is only to project from WMTS servers.

Richard Wilbrink about 3 years ago in InfoWorks ICM / GIS Layers / Import data 0 Gathering support

1 VOTE

Robust pond editor

Add options for complex pond shapes and items. Many municipalities now require items like latorial shelves, forebays, baffles, etc. these items do influence the detention time in the pond and can have effects on staging. While the size items can b...

Corey Balenger about 1 year ago in InfoDrainage / Hydraulics 0 For Review

Please enter your email address

FILTER BY CATEGORY