Ideas

Showing 113 of 1372

Easy pop up chart on image schematics

When interacting with image-schematics, instead of creating a chart in the workspace, users would like the idea to have a simple pop-up (modal) chart they can quickly view and dismiss

Pete Mcintosh over 1 year ago in Info360 Insight / Images 0 In progress

2 VOTE

Provide option to hide the "hover over" on charts

When looking at charts sometimes the hover over is distracting - i just want to see the trends. Please give users an easy option to toggle this on/off

Pete Mcintosh over 1 year ago in Info360 Insight / Workspaces 0 In progress

5 VOTE

Export river cross sections for an ICM model

At present, ICM river cross sections can only be exported to dwg one by one. It would be helpful to be able to export all the modelled cross sections in a single operation (eg via data export centre)

Guest over 4 years ago in InfoWorks ICM / Export Data / River Modeling 1 Already exists

5 VOTE

I&I BizBlock for Wastewater Collection and Transmission

To be able to use SCADA/RTU volume readings from either gravity area/velocity meters or Lift Stations (with diameter and float level readings) to calculate volume. Then there a few statistical steps to sperate Inflow from Infiltration. Additionall...

Guest over 4 years ago in Info360 Insight 0 Gathering support

5 VOTE

Data Inference Engine - ideally built on ML

As a user I want a tool that will flag and replace periods of bad data with "inferred" data applied through models/ML/ARIMA.We can only derive insights if we have good data and that is the concern of every utility. Data quality especially becomes ...

Nathan Gerdts almost 5 years ago in Info360 Insight 1 Under consideration

5 VOTE

GIS and Reporting Capabilities

I just had a meeting with Orange County, FL. They just want a tool that can do really good reporting. See example attached where you need GIS info, GIS map, SCADA data summarization and Info collected from a work order in a CMMS (Maximo in this ca...

Guest almost 5 years ago in Info360 Insight 1 Under consideration

6 VOTE

Dissolve river reaches into multiple river reaches

It would be great to have the capability to generate automatically and perfectly snapped nodes in all/some of the X-sections of one/multiple river reaches in ICM and therefore split that river reach into various river reaches (kind of the opposite...

Guest almost 6 years ago in InfoWorks ICM / River Modeling 0 Gathering support

1 VOTE

Allow to use analytics as the main KPI in the KPI component in workspaces.

Currently the KPI component in workspaces only allows to use physical sensors and excludes analytics. Analytics can only be used as comparison point. UU has created an analytic which they wish use as the main KPI in this workspace component.

Guest about 1 year ago in Info360 Insight / Workspaces 0 In progress

2 VOTE

Ability to see what Workspace(s) an Analytic is referenced in

From within an Analytic (Configuration or, more likely, Calculated Result) display the Workspace(s) the Analytic is already surfaced/referenced in for tracking purposes. This could apply to other areas in Info360 Plant to display where a particula...

Amelia about 2 years ago in Info360 Insight / Tools / Analytics 0 Under consideration

2 VOTE

Interpolate bank elevations from cross-section ends

It often happens that river reaches are constructed from traditional surveyed cross-sections, which is of a higher accuracy compared to LIDAR data. A common need is for the bank elevations between the surveyed cross-sections to be interpolated bas...

Guest over 2 years ago in InfoWorks ICM / River Modeling 0 Gathering support

Please enter your email address

FILTER BY CATEGORY