Ideas

Showing 368 of 1442

Data Sets

It would be very helpful if, for any data set that is created by creating a clone of another data set, you could keep track of that. Perhaps a visually branched system of data sets to see if any of the sets were created based on another set. That ...

Guest about 5 years ago in InfoWater Pro 1 Under consideration

2 VOTE

Infiltration Trench using BRE DIGEST 365 method

The software needs to support for designing Infiltration trench method by using “BRE DIGEST 365”. I have checked the comparison between Infodrainage analysis Vs BRE digest 365 (manual calculation) and the results are not matching. Most of the proj...

Guest about 2 years ago in InfoDrainage / Hydraulics 8 Gathering support

2 VOTE

Swale with pipe under connected by manholes

Could not model real-life scenario where the pipe was under as conveyance for lesser events and raised via vented manholes into the swale above. Need integrated solution and was unable to model both and connect via manholes.

Guest about 2 years ago in InfoDrainage / Hydraulics 1 Already exists

1 VOTE

Use consistent terminology in the Fireflow Results Report

The Fireflow Results Report uses the following terms for what I believe are the same thing: Total Demand, Design Flow, & Fire Demand. If these are not the same in the context of this report then explain their differences. Also, the term "Hydra...

Guest about 1 year ago in InfoWater Pro / Other 0 For Review

1 VOTE

Incorporate greater flexibility in the creation of UDF maps from the Print Field Journal

The current Print Field Journal for UDF maps does not allow users to adjust the map size (relative to other elements in the PDF), which was an important feature for our client when using UDF with InfoWater (the map is the most important for them i...

Guest about 1 year ago in InfoWater Pro / Productivity 0 For Review

1 VOTE

Apply direct inflows to permeable paving

There should be a way of applying the inflow that the paving receives directly (i.e. the rain that falls onto it) to produce a more accurate simulation of the rainfall. This direct rainfall isn't a lateral or point inflow, and being forced to mode...

Craig Bobbett about 1 year ago in InfoDrainage / Hydraulics 0 For Review

1 VOTE

Open Control Center on Selection, Selection Set, or Domain

For models with lots of controls, this would be helpful to quickly look a few at a time. For example, all the controls at a specific site. Right now, the list appears to be sorted randomly. It would also be helpful to automatically sort alphabetic...

Colin Ricks about 1 year ago in InfoWater Pro / Productivity 0 Under consideration

3 VOTE

Microdrainge to Revit

Make Pipes and Inlet available in Revit

Guest over 3 years ago in InfoDrainage 0 Gathering support

3 VOTE

Switch design return periods when running cascade analysis

I would like to be able to build a single cascade model & able run it for various design return periods instead of needing to create separate cascade models for each return period.

Guest over 3 years ago in InfoDrainage 1 Already exists

3 VOTE

Status Bar to report more significant figures

The status bar currently only displays levels (ground model level, water depth) to 1 decimal place. 2 Decimal places would be much more useful, Especially to ensure a node is at a low point or in the gutter invert..

Guest over 3 years ago in InfoDrainage 1 Already exists

Please enter your email address

FILTER BY CATEGORY