InfoWorks ICM

Better Hydraulic Profile CAD Export

Utilities for comparing HGLs between scenarios are limited, so sometimes you are forced to export to dwg to compare more directly. The export linework is kind of a mess - no legend, no layer naming. I would request that the linework be exported wi...

Guest 6 months ago in InfoWorks ICM / Export Data 0 For Review

2 VOTE

Asymmetrical Tanks

Currently ICM treats storage areas where there is a change in area at a certain level as symmetrical. This limits hydraulic modelling by constraining the structures that can be built. An option to account for asymmetry would be useful ( similar to...

Guest about 1 year ago in InfoWorks ICM / Ponds/Storage 1 Will not implement

10 VOTE

Using SWMM5 treatment equations at a node or link in ICM Networks

Users would like to use SWMM5 Buildup Washoff in ICM Networks AND the SWMM5 treatment equations at a node or link in the ICM St Venant solution. ICM SWMM networks have both options but for the purposes of using the powerful routing solution in I...

ROBERT DICKENSON about 5 years ago in InfoWorks ICM / Treatment / Water Quality 2 Gathering support

13 VOTE

Orifice to limit flow in both directions

A limiting discharge set on an orifice should limit flow in both directions. Currently, the orifice limits flow in the forward direction; however, flow can go in the reverse direction at an unlimited rate. Hydraulically, if there is a physical fea...

Guest almost 7 years ago in InfoWorks ICM / Hydraulics / Orifice 0 Gathering support

2 VOTE

Need for flexible rainfall assignment in 2D zones

In models created using ICM by Japanese users, it is not uncommon for both approaches—one where rainfall is applied to subcatchments and flood from the network flows over 2D elements, and another where rainfall is applied directly to the 2D zone—t...

Nami Ikarashi about 1 year ago in InfoWorks ICM / InfoWorks 0 For Review

4 VOTE

UX: Allow decimal values without a leading zero

When adjusting values - you need to enter a leading zero to adjust by non-integer values. It would be nice to simply type '.5' if you need to lower by half a unit. The anticipation and early validation of the number is needless to toss a dialog bo...

Guest about 2 years ago in InfoWorks ICM / Productivity 2 Gathering support

11 VOTE

Infoworks ICM- Sewage Temperature Modelling and Heat Losses

The following features should be added to Infoworks ICM for modelling temperature impacts for Heat extraction or heat insertion projects: - Sewage temperature to be added in WWG file as a pollutograph parameter and can also be defined in a diurnal...

Guest almost 6 years ago in InfoWorks ICM / Temperature / Wastewater 1 Gathering support

9 VOTE

As a user I want to change the amount of decimals when applying Autolabels in Infoworks ICM

I want to change the amount of decimals when I apply Autolabels in Properties and Themes. Right now the default is three decimal places which I cannot edit.

Guest almost 5 years ago in InfoWorks ICM / Labels 1 Gathering support

12 VOTE

Infoworks - Pipe grade calculator

Pipe grade calculator between US and DS inverts, Ultimately having the ability to calculate downstream or upstream inverts over a long network based on a specified grade from either a DS or US invert level as a starting point.

Guest over 6 years ago in InfoWorks ICM / Hydraulics 1 Gathering support

10 VOTE

Show worst case analysis on long sections

I would like to be able to see the worst case across multiple simulations (highest water levels) along the 1d network when reviewing results. Essentially being able to visualize statistical report results in a long section.

Guest over 5 years ago in InfoWorks ICM / Long Section / Profile / Results 1 Gathering support

Please enter your email address

FILTER BY CATEGORY