All ideas

Optimizing Asset Management with Classes in Info360 Plant

Currently, in Info360 Plant, when creating a common analytic or workspace for the same type of asset (e.g., a pump or a set of pumps), it is necessary to manually create the analytic or workspace for each asset. This process is facilitated through...

Javier Coronado over 1 year ago in Info360 Insight / General 0 For Review

4 VOTE

Ability to select multiple upstream traces at once

It would be useful to be able to hold ctrl / shift / alt or another keyboard link to be able to visualise multiple upstream traces at once. So after one trace has been selected, we could hold a key down and make another selection and retain all tr...

Lydia Crowther about 3 years ago in InfoWorks ICM / Network 0 Gathering support

2 VOTE

Multiple Output Blocks for Analytics Configuration

Currently, output blocks can only provide one output. This means multiple output blocks are needed for multiple calculations in a single analytic. Output blocks should be able to provide multiple outputs to simplify the analytic configuration.

Javier Coronado over 1 year ago in Info360 Insight / Tools / Analytics 0 For Review

2 VOTE

Copy and Paste of Blocks within Analytics Configuration

To make editing analytics configuration easier, it should be possible to copy and paste data sources, constant values, and output blocks within the configuration.

Javier Coronado over 1 year ago in Info360 Insight / Tools / Analytics 0 For Review

2 VOTE

Adding Comments in Analytics Outputs Blocks

Like any code, comments should be added to any Analytic Output. This will facilitate the understanding of the calculations within the Analytic. I suggest that these comments should be added as a description within the output definition or as a tex...

Javier Coronado over 1 year ago in Info360 Insight / Tools / Analytics 0 For Review

4 VOTE

Display linked live data in long section view

When calibrating a model with multiple pressure loggers, it would be useful to see reference HGL's in the Long Section view at any points with live data. This could be represented as floating points based on the current timestep. This helps unders...

Nathan Gerdts about 3 years ago in InfoWorks WS Pro / Telemetry 0 Gathering support

1 VOTE

make easier the result analysis

make easier the result analysis, by editing the results (e.g volume in en pipe) at a given timestep (e.g. daily, hourly...)

Christophe LECLERC 9 months ago in InfoWorks ICM / Statistics 0 For Review

4 VOTE

Add SuDS Planner tool to InfoDrainage

It would be good if we have the "SuDS Planner" tool available inside InfoDrainage similar to the one we have in MicroDrainage-Source Control module

Dilraj KT about 3 years ago in InfoDrainage / Other 3 Gathering support

4 VOTE

Reference Patterns in Analytics, Alerts, and Reference charts

The Pattern tool allows me to report common reoccuring behavior in the system. I would like to call these patterns as a reference in analytics and alerts to identify and report anomalous events in data when flows exceed the typical pattern on a hi...

Nathan Gerdts about 3 years ago in Info360 Insight / Tools / Analytics 1 Under consideration

8 VOTE

Speed up interfaces with 2D zones with millions of elements (make it a multicore process)

The interface for large 1D-2D models is very slow. While moving through the geoplan every time it takes about ten seconds to load and show the location. We noticed that in this time only 1 of the 32 CPU is used for 100%. We tried 2 complete differ...

Bram Stuurman about 6 years ago in InfoWorks ICM / Performance 1 Gathering support

Please enter your email address

FILTER BY CATEGORY