Ideas

Showing 380 of 1442

Populate Pump run schedule based on telemetry data in WS Pro

As a planning modeler calibrating within WS Pro, I want to use the "Load from Live Data" tool on pumps in Plan mode to populate the Control Data timeseries profile based on a data stream of 1's and 0's indicating on/off. While this is already avai...

Guest over 4 years ago in InfoWorks WS Pro / Telemetry 0 Gathering support

1 VOTE

Open/Closed Valve Control - Live Data

When using an open/closed valve, setting a time profile to describe the opening and closing pressures, it would be useful to be able to load values form Live Data. It should be possible to connect the valve to 2 different live datas: one live data...

Paolo Boiardi over 1 year ago in InfoWorks WS Pro / Engine 0 For Review

3 VOTE

WS Pro control should be based on current time step

Add option in WS Pro so that control status of objects is controlled by the flow solution in the current time step, not the previous time step. The way WS Pro currently works, with the control based on the previous TS often results in pump on/off ...

Haddon Smith almost 5 years ago in InfoWorks WS Pro / Engine 0 Gathering support

1 VOTE

Demand Area Analysis for partially metered areas

Demand Area Analysis was originally intended for networks where the unprofiled demand was unmetered. When domestic (unprofiled) metering became more prevalent Innovyze introduced “Current Average Specific Consumption (l/p/day)” in the calculation ...

Guest over 1 year ago in InfoWorks WS Pro / Productivity 2 For Review

1 VOTE

Orifice and Grate options - Outlet Control Structure

I suggest incorporating advanced features for modeling orifices and grates. Specifically, the following modifications would be beneficial: Orientation Settings: Introduce options to define the orientation of orifices and grates, allowing users to ...

Guest over 1 year ago in InfoDrainage / Hydraulics 0 For Review

3 VOTE

Multiple control options

Assets with controls (Pumps, PRVs etc.) should have multiple control options. So Control 1 could be a control regime applicable to model calibration. Control 2 could be control relevant to a General Applications model, Controls 3, 4, 5 etc c...

Guest about 5 years ago in InfoWorks WS Pro / Productivity 1 Already exists

2 VOTE

Print Tickbox for Manhole Schedule Layout option

In MicroDrainage 2019.1 the Manhole Schedule printout also includes a manhole layout, sometimes this is unnecessary and it would be helpful if there was an additional tickbox option in the printout settings.

Guest over 3 years ago in InfoDrainage 0 Gathering support

2 VOTE

Allow SOIL values < 0.15

The Rural Runoff estimate tool in MDSUDS does not allow values of SOIL below 0.15. The UKSUDS greenfield runoff tool defaults to a value of SOIL=0.1 where SoilType=1 This produces a significant difference in results. This difference results from u...

Guest over 3 years ago in InfoDrainage 0 Gathering support

2 VOTE

Design settings which only allows backdrops in pipe diameters below 225mm diameter

No description provided

Guest over 3 years ago in InfoDrainage 0 Gathering support

2 VOTE

Assess scenarios based on annual water balance (runoff, infiltration, evaporation)

Assessment of the annual water balance is an important criteria to evaluate drainage design at neighbourhood level. Functionality to assess scenarios in a chart (similar to typical pre-urban vs. urban) would save time in GIS-postprocessing

Guest over 3 years ago in InfoDrainage 0 Gathering support

Please enter your email address

FILTER BY CATEGORY