Ideas

Showing 380 of 1442

Swale with pipe under connected by manholes

Could not model real-life scenario where the pipe was under as conveyance for lesser events and raised via vented manholes into the swale above. Need integrated solution and was unable to model both and connect via manholes.

Guest about 2 years ago in InfoDrainage / Hydraulics 1 Already exists

4 VOTE

Temperature variation for the PSO bulk chlorine decay model in the MSQ module of InfoWorks

The reactive-constituent (PSO) chlorine decay model (Fisher et al. 2017) was provided to users in the MSQ module of InfoWorks in July 2020 (see the MSQ blog for details). A major advantage of this model is that only a single set of four model coef...

Guest over 4 years ago in InfoWorks WS Pro / Engine 1 Gathering support

1 VOTE

Allow sequencing of simulations and selections lists

It would be good if we can change the sequence of the simulations, selection sets etc to make them easier to find - especially when creating different scenarios

Ashwini about 1 year ago in InfoWorks WS Pro / Other 1 For Review

1 VOTE

Apply direct inflows to permeable paving

There should be a way of applying the inflow that the paving receives directly (i.e. the rain that falls onto it) to produce a more accurate simulation of the rainfall. This direct rainfall isn't a lateral or point inflow, and being forced to mode...

Craig Bobbett about 1 year ago in InfoDrainage / Hydraulics 0 For Review

2 VOTE

Basemap support

The current x64 version of WS Pro doesn't seem to be able to use the ArcEngine / ArcGIS Desktop functionality, in contrast to previous x32 bit versions? Since only x64 bit version is now supported, this feature cannot be used. It is one of the mos...

Guest about 2 years ago in InfoWorks WS Pro / Other 2 In progress

5 VOTE

Sort selection sets/ re-order them

Would be very useful if you could either sort selection set orders or move selections up or down the list. This would make it much faster to find the selection set you want in a large list (e.g. DMA selection sets in alphabetical order)

Duncan Allen over 5 years ago in InfoWorks WS Pro 1 Gathering support

1 VOTE

Improve Theme Symbol Support

While setting up a custom theme to align WS Pro more closely to our GIS, I've found the support for symbols quite limited, and think these would be worthwhile improvements: Support the use of custom SVG icons, and/or Support the use of non-system...

Dave Watts about 1 year ago in InfoWorks WS Pro / Other 0 Gathering support

3 VOTE

Microdrainge to Revit

Make Pipes and Inlet available in Revit

Guest over 3 years ago in InfoDrainage 0 Gathering support

3 VOTE

Switch design return periods when running cascade analysis

I would like to be able to build a single cascade model & able run it for various design return periods instead of needing to create separate cascade models for each return period.

Guest over 3 years ago in InfoDrainage 1 Already exists

3 VOTE

Status Bar to report more significant figures

The status bar currently only displays levels (ground model level, water depth) to 1 decimal place. 2 Decimal places would be much more useful, Especially to ensure a node is at a low point or in the gutter invert..

Guest over 3 years ago in InfoDrainage 1 Already exists

Please enter your email address

FILTER BY CATEGORY