Productivity

Save phase results seperately

When working with multiple phases I would like to be able to run one phase (exclude all others from analysis) and have the results saved. Results should only be overwritten when a new run on the same phase is completed.

Andrew Komarnycky over 1 year ago in InfoDrainage / Productivity 0 For Review

6 VOTE

Graphical editing in Longsection

Being able to manually drag pipes up/down and alter their gradient in the long section graphics, was an extremely efficient workflow in Microdrainage, especially when using min. pipe design levels to dictate land-raise FGLs. Can this function be c...

Guest over 1 year ago in InfoDrainage / Productivity 0 For Review

5 VOTE

Ability to look at multiple phases (surface and foul networks together) in 3D

Being able to view both surface and foul networks within MicroDrainage was always a very useful feature to visualise crossing points in the network and it doesn't look to have been included in InfoDrainage.

Henry Wilkinson about 1 year ago in InfoDrainage / Productivity 1 For Review

11 VOTE

Allow different Phases to use the same background files

When creating a new network through phasing we often wish to use the same CAD levels and background used by another network, without having to load another version of the same CAD files.

Guest almost 3 years ago in InfoDrainage / Productivity 1 Will not implement

2 VOTE

Retaining CAD files / Orphaning

When CAD files are imported to InfoDrainage they retain the link to the CAD file, like a CAD Xref which is good. However if that file is moved, or InfoDrainage cannot access it, an error box is prompted and the entire CAD file is just deleted from...

Ian George 7 months ago in InfoDrainage / Productivity 1 In progress

4 VOTE

Pipe clash detection when foul network phase is active

When working through clashes between surface water and foul networks, you can only access the pipe clash analysis within surface water analysis tab. This means if I want to change the depth of the foul network to avoid the clash then I have to swa...

Henry Wilkinson about 1 year ago in InfoDrainage / Productivity 1 For Review

2 VOTE

Add max pipe flow to the pipe properties window

Max pipe flow (theoretical pipe full) is not listed in pipe properties, as it was previously in MicroDrainage. It was a useful feature.

Ian George 8 months ago in InfoDrainage / Productivity 0 For Review

6 VOTE

Show manhole types in manhole schedule export

Manhole schedules need to feature cover types (D400, C250 etc), manhole types (Type A, B, C in Scotland etc) and whether they're a backdrop or a headwall etc. Having a feature to assign this based on location on site (cover type), depth to soffit ...

Guest about 2 years ago in InfoDrainage / Productivity 0 For Review

7 VOTE

"Show Maxima" Button

It would be great if there were a "show maximum" button like there is in InfoWorks ICM where you can see at what point in the simulation there is the most surcharge. this would save time trying to manually move the timeline to exactly where someth...

Midori Patterson over 2 years ago in InfoDrainage / Productivity 1 Gathering support

3 VOTE

Reverse Flow Direction

In cases where the pipe direction in the CAD/GIS source file is incorrect, the imported flow direction in InfoDrainage also follows the same (incorrect) path. Rather than correcting the geometry externally in CAD or GIS, is there a built-in option...

Jana Anbu over 1 year ago in InfoDrainage / Productivity 2 Will not implement

Please enter your email address

FILTER BY CATEGORY