Ideas

Showing 150 of 1442

Level Soffits in pipe network.

Although you can select Level Soffits in the Network Wizard, if you make a change in the manhole depth for example, the pipes in the network will return to invert level, which means that you will have to readjust them manually.

Konstantinos Koutroulis about 2 years ago in InfoDrainage / Hydraulics 1 In progress

9 VOTE

Permeable Pavement with varying depth

Please add an option to input the surface slope and formation level slope for the permeable pavements to represent the varying depth of storage below. This is one of the 3 options we use at steeper sites to provide adequate storage in permeable pa...

Dilraj KT over 1 year ago in InfoDrainage / Hydraulics 0 For Review

8 VOTE

Option to remove the additional storage automatically added in geocellular systems

When designing a cellular soakaway, infodrainage automatically assumes a 1m2 plan area chamber between tank soffit and exceedance level (which would have been specified as ground level). In other structures you can specify freeboard and exceedance...

Guest over 1 year ago in InfoDrainage / Hydraulics 3 For Review

25 VOTE

Zoom graphs on either axis

Many software suites allow the option to zoom in on both y and x axes on their graphs. However, ICM only allows zooming on the x-axis which often takes away the ability to see trends for lower or higher conditions. I am aware that it is possible t...

Guest over 4 years ago in InfoWorks ICM / Calibration / Productivity / Results 4 Gathering support

11 VOTE

Perforated Pipe as Connection Type

I would like to be able to model a perforated pipe as a connection type rather than use an infiltration trench and short branches of pipes to connect them to other stormwater controls. These infiltration trenches are not collecting inflow from sur...

Midori Patterson about 2 years ago in InfoDrainage / Hydraulics 1 Gathering support

16 VOTE

Cross section result view: keyboard shortcuts to go upstream or downstream

In the cross section result view (showing the water level), in RS there was the possibility to go upstream or downstream with PageUp/PageDwn, in ICM you have to right click to move upstream or downstream

Guest about 3 years ago in InfoWorks ICM / Productivity / Results / River Modeling 0 Gathering support

16 VOTE

Bank line ground model update from within properties view

Make update from ground model possible from within properties view (as is already possible for cross sections)

Guest about 3 years ago in InfoWorks ICM / River Modeling 0 Gathering support

6 VOTE

Incorporate the ability to create custom grate inlets. Currently InfoDrainage only allows for HEC22 defined inlet grate types to be used.

Some municipalities across New Zealand and other parts of the world require designers to use specified inlet grate types with defined inlet efficiency curves. There are two ways in which the custom inlet grate type this can be incorporated into In...

Quinton Botha about 1 year ago in InfoDrainage / Hydraulics 2 For Review

28 VOTE

Statistic Report Batch Processing

As a user the ability to 'schedule' statistical reports would be extremely useful. currently if i'm generating a spill report on several overflows for a 10yr TSR series this can take several hours. The process effectively locks the software and pr...

Jason Drake almost 6 years ago in InfoWorks ICM / Productivity / Results 4 Gathering support

6 VOTE

Non-circular pipes

Please add non-circular pipes to InfoDrainage, similar to those available SSA. These need the ability to connect to manholes at either end at a minimum, but the option to be culverted as well is welcomed.

Guest about 1 year ago in InfoDrainage / Hydraulics 1 For Review

Please enter your email address

FILTER BY CATEGORY