InfoDrainage

Showing 32

Bioretention Underdrain Slope / Additional layer Options

Virginia specifications for a bioretention requires the underdrain to have a slope to it, but Infodrainage slope does not allow for this in the SWC bioretention SWC. Also, we sometimes have to place the underdrains in a trench below the storage la...

Jenna Woyner 12 months ago in InfoDrainage / Hydrology 2 Already exists

4 VOTE

3D View of flooded manholes

The extent of flooding in the 3D view should be proportional to the volume of flooding of that manhole. At the moment it shows the same extent of flooding whether it's 0.1m3 or 100m3. Would make visualisation the extent and location of flooding on...

Guest 8 months ago in InfoDrainage / Visualization 1 Already exists

14 VOTE

Run same return period with multiple climate change allowances

When running the simulation wizard I would like to be able to run the same return period with multiple climate change allowances to enable a single analysis covering all scenarios. This will avoid needing to adjust inputs & rerunning the netwo...

Guest over 2 years ago in InfoDrainage 1 Already exists

11 VOTE

True Ground Profile on Long Section Exports

It would be very useful if there was a way for the true ground profile to also be exported on long sections. Currently, when exporting long sections from microdrainage, the true ground levels are only shown at manhole locations and a straight line...

Guest over 2 years ago in InfoDrainage 2 Already exists

10 VOTE

Manhole Schedule Numbering

For MH tables and report outputs, it would be good to have an option to report chronologically, e.g. 1-30. I understand it numbers them on the first Manhole built in the model however I think it would make more sense to go from shallowest to deep...

Guest over 2 years ago in InfoDrainage 3 Already exists

4 VOTE

Add a Brownfield Runoff tool under Preliminary Sizing > Calculators in the ribbon

To assist with initial site assessment, a brownfield runoff tool with printable reporting for the chosen rainfall events would be useful in the Preliminary sizing ribbon to allow analysis of brownfield and greenfield runoff rates from the same loc...

Guest almost 1 year ago in InfoDrainage / Hydrology 2 Already exists

3 VOTE

Display multiple networks in 3D.

In order to aid the layout design of drainage networks, it would be useful to see both foul and surface water sewer networks simultaneously, in the 3D view. This would allow designers to see the clearance between pipes and chambers and have piece ...

Guest about 1 year ago in InfoDrainage / Visualization 3 Already exists

6 VOTE

Exceedance Level in Infodrainage

It would be good to have an option in underground stormwater controls to have a separate option for exceedance level and Ground Level By taking the exceedance level as GL, it makes the Long sections look distorted when in reality it is common for...

Guest over 2 years ago in InfoDrainage 1 Already exists

6 VOTE

InfoDrainage - Permeable Paving

It would be useful to have a central granular conveyance trench beneath permeable paving to avoid the need for overly deep sub base beneath the road / drive.

Guest over 2 years ago in InfoDrainage 1 Already exists

2 VOTE

Add Gravel Pit to Soakaway Design Tool

As a former MicroDrainage user, I'm struggling to model soakaways in InfoDrainage, as InfoDrainage does not account for storage volume within the gravel filter media that surrounds the soakaway. The gravel pit also provides larger area of infiltra...

Aleks Persins 12 months ago in InfoDrainage / Hydraulics 2 Already exists

Please enter your email address

FILTER BY CATEGORY