InfoWorks ICM

Showing 71

Minimum mesh element area

As we are aware that "Minimum mesh area" will be used in calculating the results. However, presently there is no specific function that directly displays the min mesh element area generated and its associated element ID. Validation needs to be per...

Guest about 2 years ago in InfoWorks ICM / Hydraulics 1 Launched

8 VOTE

Bulk river reach build process

If the river reach build all is reinstated, it would be great if it could be conducted on a selection of river reaches rather than on a case by case basis.

Guest almost 6 years ago in InfoWorks ICM 0 Launched

4 VOTE

section view of ground model and 2d mesh

It would be very usefull to be able to generate a section view of both a ground model and a generated 2d mesh. At the moment this is only possible in a flood section after a simulation. So it should be not too difficult to move this possibility ...

Richard Wilbrink about 3 years ago in InfoWorks ICM / 2D Flooding / Hydraulics / Terrain / Visualization 1 Launched

8 VOTE

Export 2D Result to Raster Grid of Depth and Hazard

Damage Assesment tools (third-party) require depth and hazard raster grid input

Guest about 6 years ago in InfoWorks ICM / 2D Flooding / Results 1 Launched

4 VOTE

Guidance (including examples) and solver assumptions in ICM help

Could the ICM help be refreshed/updated and include more examples and/or details of the physics / assumptions / settings used by the simulation solver? Some examples below - Orifice control – Technical paper “Orifices” (June 2005) is not available...

Giorgio Incelli about 3 years ago in InfoWorks ICM 0 Launched

7 VOTE

Individual vertex point visibility in GeoPlan

When an individual point is selected in river section data, this is not dynamically shown on the GeoPlan like a cross section might be. It would be good if vertex points were also visible.

Guest almost 6 years ago in InfoWorks ICM 1 Launched

7 VOTE

Mesh result smoothing

Automated smoothing of flood depths from mesh elements, giving a less jagged appearance.

Guest about 6 years ago in InfoWorks ICM 1 Launched

6 VOTE

Route subcatchment outflow directly to a point on the 2D mesh

At times I want to route subcatchment flow to a certain point on the 2D mesh. This could be for directing building runoff to the street/curb or simply making sure the runoff gets to the inlet structure without forcing it into the underground netwo...

Guest over 5 years ago in InfoWorks ICM 2 Launched

2 VOTE

More display decimal places for small values of Dry Weather Flow

In 2024, with larger simulation models and more monitoring data, a model's dry weather loading is likely to be less than 0.005 MGD, CFS, or CMS. ICM InfoWorks only supports these three unit types. For low flows, the node, link, and subcatchment gr...

Robert Dickinson almost 2 years ago in InfoWorks ICM / Grids 2 Launched

6 VOTE

Straighten section tool

At the moment it is possible to have non straight survey sections brought in, which may result in incorrect cross section lengths, straightening these was possible in RS, it would be good to have the same in ICM.

Guest about 6 years ago in InfoWorks ICM 0 Launched

Please enter your email address

FILTER BY CATEGORY