Ideas

Showing 107 of 1370

Status Transfer for Critical Channels in Info360 Plant

To enable Info360 Plant to transfer a "status" for channels, allowing users to establish when a critical channel is missing data. Current Situation: Info360 Plant currently has value mapping capabilities, but there are limitations: Setting the val...

Javier Coronado 9 months ago in Info360 Insight / Admin / Global Changes 0 For Review

3 VOTE

Cross Section view of channels/weirs

Some hydraulic analysis reports require a cross section view of HGLs/EGLs of weirs, channels, or ponds. See attached image.

Tim Medearis 9 months ago in InfoDrainage / Visualization 0 For Review

2 VOTE

Display Inflow catchment areas to 3 decimal places in plan view

Displaying network information in plan view, which is displayed when exported to CAD is great, however the decimal rounding is only to 2 decimal places. It would be good for the display to be rounded to 3 decimal places so it can be easily correla...

Guest 6 months ago in InfoDrainage / Visualization 0 Gathering support

3 VOTE

Adding references to Analytics

An analytic is created to be referred within other instance in the platform, whether another analytic or a workspace. When the analytic is created and later modified or deleted, the analytic owner must understand the impact of such modification or...

Javier Coronado 10 months ago in Info360 Insight / Tools / Analytics 0 Gathering support

3 VOTE

Tariff Scheduling

Energy tariffs in water and wastewater treatment plants are often defined hourly by an energy operator. This correspondingly defines low- and high- tariff periods. When a customer desires to track energy consumption and estimate its cost through I...

Javier Coronado 10 months ago in Info360 Insight / General 0 For Review

3 VOTE

Analytics and Workplaces Ownership

When multiple users work in parallel, it is key to trace work changes. For example, if user A creates an analytic that must later be modified by user 2, both user2 and user1 must be aware of creation and modification ownership. This becomes critic...

Javier Coronado 10 months ago in Info360 Insight / General 0 Under consideration

3 VOTE

Adding MIN and MAX as functions within Analytic Tool

It is common practice, when calculating analytics from field sensors to leverage Min and Max to avoid miscalculations. For example, a sensor signal, when faulty, may become negative, while commonly having a positive value. To avoid this, a simple ...

Javier Coronado 10 months ago in Info360 Insight / Tools / Analytics 0 For Review

3 VOTE

Allow changing graphic order when creating historical charts

When building a historical chart, Info360 overlays the sensors in the same order as they are configured. When the visualization of a sensor is an area, and this sensor is not added first, then the area will overlay the trends for the other sensors...

Javier Coronado 10 months ago in Info360 Insight / Workspaces 0 For Review

6 VOTE

CAD Data Layer Controls

When you have your CAD files in the drawing, you can control what layers show up. However, you can only select one at a time, you can't sort, and often your selections will reset. This would improve the plan view controls quite a bit.

Jess Ewing over 1 year ago in InfoDrainage / Visualization 1 Gathering support

4 VOTE

Forecast and calc channels for analytics

To benchmark process performance, customers require comparing pre- and post- efficiency enhancement. In the case of UU, they can compare theoretical (pre-AI) vs. eff. enhanced (post-AI) vs. recommended (AI). Forecast channels from emagin cannot be...

Javier Coronado about 1 year ago in Info360 Insight / Tools / Analytics 1 In progress

Please enter your email address

FILTER BY CATEGORY