Ideas

Showing 15 of 1370

Design ARV & Washout size - Simulate losses & airflow during system drain down

As a planning and design team, we need to size air valves and wash outs for our system so that large pipes can be drained for maintenance in a timely manner. InfoWorks WS Pro models the draindown of water after isolation, but it doesn't take into ...

Nathan Gerdts about 2 months ago in InfoWorks WS Pro / Operations 0 For Review

4 VOTE

Pump Station Operation Narrative

Would like the ability to add a pump station narrative. For example, a station may have several pumps and varying set points, however those set points do not relate to a specific pump. The station may operate where once the first set point is reac...

Dave White about 1 year ago in InfoWorks ICM / Pumps 0 For Review

3 VOTE

Add a feature for deselection of a group of elements in Geoplan

Many times we use polygon select feature to select elements in a particular extent, but there is no option of deselecting a small area within that selection - like in Arc Map

Ashwini 10 months ago in InfoWorks WS Pro / Operations 1 Gathering support

9 VOTE

Pump Station Modelling

Infoworks ICM pump station modelling principle is very basic, adding a pump between two nodes is highly hypothetical. There is no way to add pump station head losses. I would like to suggest incorporating pump station modelling (for Rotodynamic pu...

Guest over 3 years ago in InfoWorks ICM / Hydraulics / Pumps 1 Gathering support

5 VOTE

Inlet pump

We are mode and more incorporating surface water systems in our ICM models and part of those systems are inlet pumps that respond to the downstream levels instead of the upstream levels. Up until now, the only way to achieve this is by creating an...

Marcel Glasbergen over 2 years ago in InfoWorks ICM / Pumps / RTC 0 Gathering support

1 VOTE

Option to compare Simulations of different time ranges superimposed on one graph [IWLive]

As an operator, I want to compare today's forecasted operations with different days in the past so I can see alternative ways how similar situations played out and make decisions with confidence. IWLive already offers functionality to compare two ...

Nathan Gerdts 7 months ago in InfoWorks WS Pro / Operations 0 For Review

2 VOTE

Distribution Network Energy Optimization

Minimize the pumping costs of water distribution while satisfying water demand and operational constraints (water levels, pressure, pump station capacities, future maintenance operations, etc).

Nathan Gerdts over 1 year ago in InfoWorks WS Pro / Operations 0 Gathering support

7 VOTE

Add SWMM5 Ideal Pump to InfoWorks ICM

Does InfoWorks ICM have an equivalent to an ideal pump in SWMM which pumps whatever is entering the SPS out of the SPS? It would be a good feature to include into infoworks as I needed to play around a bit to get it. I found I had to add line 2 ...

Guest about 6 years ago in InfoWorks ICM / Hydraulics / Pumps 1 Gathering support

3 VOTE

Calculation of Pump Power in ICM

A pump curve and energy/efficiency curve can be input into the software however there is no way to output the energy used by the pump. South Gippsland Water were keen on understanding whether ICM could do this to report their energy efficiency bas...

Ann Pugh almost 5 years ago in InfoWorks ICM / Pumps 0 Gathering support

3 VOTE

I would like the option to model pump station that operate using VFDs.

I would like to be able to enter the full and reduced speed pump curves for each pump station that is controlled by variable frequency drives. In addition, I would need the set point or control that causes the pumps to ramp up to full speed.

Guest over 5 years ago in InfoWorks ICM / Pumps 0 Gathering support

Please enter your email address

FILTER BY CATEGORY