When simulating models, it is often necessary to consolidate the values in a H/Q curve to retain the hydraulic performance but optimize the simulation speed. As during previous correspondence with the InfoWorks support team, this has been advised and found to significantly improve simulation speed. Hydrobrake manufacturers often produce these curves with lots of points that aren't needed hydraulically, could the software have an option to optimise these automatically rather than manually . See attached
Disclaimer: The development, release, and timing of any features or functionality described or discussed for our products in this User Feedback Forum for Autodesk Water Products and Services remains at our sole discretion. This User Feedback Forum for Autodesk Water Products and Services is not a commitment, promise, or legal obligation to deliver any functionality, is intended solely to outline and gather feedback about our general product direction, and should not be relied on in making purchasing decisions.