Ideas

Showing 320 of 1373

Infiltration Trench using BRE DIGEST 365 method

The software needs to support for designing Infiltration trench method by using “BRE DIGEST 365”. I have checked the comparison between Infodrainage analysis Vs BRE digest 365 (manual calculation) and the results are not matching. Most of the proj...

Guest almost 2 years ago in InfoDrainage / Hydraulics 8 Gathering support

2 VOTE

Swale with pipe under connected by manholes

Could not model real-life scenario where the pipe was under as conveyance for lesser events and raised via vented manholes into the swale above. Need integrated solution and was unable to model both and connect via manholes.

Guest almost 2 years ago in InfoDrainage / Hydraulics 1 Already exists

5 VOTE

I&I BizBlock for Wastewater Collection and Transmission

To be able to use SCADA/RTU volume readings from either gravity area/velocity meters or Lift Stations (with diameter and float level readings) to calculate volume. Then there a few statistical steps to sperate Inflow from Infiltration. Additionall...

Guest over 4 years ago in Info360 Insight 0 Gathering support

5 VOTE

Data Inference Engine - ideally built on ML

As a user I want a tool that will flag and replace periods of bad data with "inferred" data applied through models/ML/ARIMA.We can only derive insights if we have good data and that is the concern of every utility. Data quality especially becomes ...

Nathan Gerdts almost 5 years ago in Info360 Insight 1 Under consideration

5 VOTE

GIS and Reporting Capabilities

I just had a meeting with Orange County, FL. They just want a tool that can do really good reporting. See example attached where you need GIS info, GIS map, SCADA data summarization and Info collected from a work order in a CMMS (Maximo in this ca...

Guest almost 5 years ago in Info360 Insight 1 Under consideration

1 VOTE

Correct resizing of pop-up windows activated through C3D toolbar

Due to issues with my eyesight I use the accessibility settings on my computer to increase the standard text sizes for applications. When using the InfoDrainage toolbar in Civil 3D pop-up menus don't resize to match the updated display settings. I...

Michael McWhinnie about 1 year ago in InfoDrainage / Other 0 For Review

3 VOTE

Microdrainge to Revit

Make Pipes and Inlet available in Revit

Guest about 3 years ago in InfoDrainage 0 Gathering support

3 VOTE

Switch design return periods when running cascade analysis

I would like to be able to build a single cascade model & able run it for various design return periods instead of needing to create separate cascade models for each return period.

Guest about 3 years ago in InfoDrainage 1 Already exists

3 VOTE

Status Bar to report more significant figures

The status bar currently only displays levels (ground model level, water depth) to 1 decimal place. 2 Decimal places would be much more useful, Especially to ensure a node is at a low point or in the gutter invert..

Guest about 3 years ago in InfoDrainage 1 Already exists

3 VOTE

Support Biodiversity net gain

Support the ability to create a biodiversity metric for SuDS structures as per the Defra tool.

Guest about 3 years ago in InfoDrainage 1 Gathering support

Please enter your email address

FILTER BY CATEGORY